Ps3 Super Slim Blu Ray Laser

Introduction

The guide will prove users how to remove the laser lens of the PlayStation 3 Super Slim. Past showing the removal of the correct screws and cables, the guide will be able to give users the ability to remove their optical drive from its enclosure. Afterward removing the optical drive, The user will open upwardly the optical bulldoze to exist able to remove the laser lens. This allows for the replacement of a component of the PlayStation three Super Slim that reads the Blu-Ray discs.

• Remove the side HDD bay embrace past sliding the panel towards the back of the device.

• The bay cover is plant on the right side of the device.







• Remove all three black 9.8mm long screws with a T-8 security screwdriver.

• Remove the bluish 7.9mm long screw with a Phillips #1 screwdriver.

• Pull on the tab to remove the HDD.

• The HDD should be removed and stored carefully to prevent damage to information.

• On the bottom of the device, pry out the three rubber feet covers with the metal spudger.

• Remove the four black 36.3mm long screws underneath with a Phillips #1 screwdriver.

• One spiral is located underneath the warranty sticker. This sticker can either be peeled off or punctured through with a screwdriver.

• On the pinnacle of the device, unlatch the hook on the furthest right beneath the front panel, lift the panel slightly and apply pressure.

• Unlatch the second right-side hook past sliding a plastic opening tool in the marked area.

• Slide the panel to the left to unlatch the rest of the hooks.

• This is probably the nearly difficult part of the procedure. If you cannot unlatch the hook on the front panel, you can attempt to pry all the hooks off. However, do this at your own adventure, as these hooks break easily.

• Remove the back panel by pressing downwards the tab on the right side of the device, and sliding the panel to the left.

• Remove the five silver 20.8mm long screws with a Phillips #1 screwdriver.

• Remove the two black 9.9mm long screws in the disc reader with a T-8 security screwdriver.

• Remove the top blackness plastic shell.

• Motility the optical drive to the side to reveal one of the silver 8.8mm long screws.

• Remove the two silver 8.8mm long screws on either side with a Phillips #ane screwdriver.

• Remove the cablevision from the plug and remove the wires from the two plastic hooks.

• When removing the cablevision from the plug, pull on the plastic male connecter, not on the wires.

• Remove the power supply unit.

• Remove the front white flex-ribbon cable past pulling upward from its base of operations.

• Remove the black and blueish flex-ribbon cable backside it by pulling upward on the black tab, then pulling out the cable.

• Rotate the device 180 degrees.

• Remove the back white flex-ribbon cable by pulling upward from its base of operations.

• Remove the optical drive.

• Elevator up the gratis terminate of the laser lens to divide the two layers.

• On the bottom of the laser lens, flip up the black plastic latch to remove the flex ribbon cable.

• Remove the 4 rubber bushings.

• Remove the metal faceplate from the laser lens.

• When inserting your new lens, attach the top metallic casing to the replacement laser lens.

Conclusion

To reassemble your device, follow these instructions in opposite club.

Team

Embed this guide

Choose a size and re-create the code below to embed this guide as a minor widget on your site / forum.

Preview

Source: https://www.ifixit.com/Guide/PlayStation+3+Super+Slim+Laser+Lens+Replacement/62764

Posted by: linnevies2001.blogspot.com

Share this post